Looking at the Bentleys manual it looked like a simple job and it was. Very fiddly getting the cable off and especially back on to the back of the Speedometer but otherwise an nice easy job.
The cable runs neatly through a hole in the floor and then through a few clamping points under the bus. It did involve a bit of a crawl around on the floor but one of the advantages of standard ride hight is that I didn't even need to jack up the bus to get this done.
The wheel end was easy (once I found the hole from the rear. It needed a little wiggling to come all the way through and out the front of the hub. Then is was just a case of trying to hold it there whilst pushing on the circlip.
Job done.
No comments:
Post a Comment